HOME
ABOUT US
Company Profile
Factory Overview
Partners
Certification
PRODUCTS
Heat Shrink Boots/Breakouts
Straight heat shrink boots
Straight heat shrink boot
90° bend heat shrink boots
90° bend heat shrink boot
Y shaped 2 ways heat shrink breakouts
Y shaped 3 ways heat shrink breakouts
Y shaped 4 ways heat shrink breakouts
DR-150 Heat Shrink Tubing
DR150 Military standard oil resistant heat shrink tube
Dual Wall Heat Shrink Tube
DW125 Dual wall adhesive lined heat shrink tubing
PVDF Heat Shrink Tubing
PVDF heat shrink tubing
150 ° C flame retardant KYNAR heat shrinkable tube
V200 Fluoro Rubber Heat Shrink Tubing
High temperature resistant 200℃ fluoro rubber heat shrink tubing
K135 Single Wall Heat Shrink Tubing
K135 Soft Flame-retardant Heat Shrink Tubing
Shrink sleeve thin-walled without glue
Label Heat Shrink Tubing
TMS135 Label heat shrink tubing
Heavy Duty Heat Shrink Tubing
6:1 shrinkage heavy duty heat shrink tubing
Shrink sleeve medium-walled with or without adhesive
Shrink sleeve thick-walled with adhesive
Non Slip Heat Shrink Tubing
NC125 Non slip textured heat shrink tubing
Cold Shrink Tubing
Cold shrink tube
Solder Sleeve
SR125 Solder sleeve/ Solder seal wire connectors
Heat Shrink Sealing Cap
Heat shrink sealing cap
End cap with glue
Heat Shrink Cable Wrap
Heat shrink cable wrap
Open shrink sleeve medium-walled with adhesive
Open shrink sleeve medium-walled, fibre-reinforced with adhesive
Electrical Equipment Package
Connection socket
Stop socket
End socket
Moulded piece with glue
Phase marking without glue
Shrink tape
NEWS
CASE
KNOWLEDGE
FAQ
CONTACT
‹
›
Shrink ratio ≥3:1
Sealed, waterproof, anti-corrosion
Continuous working temperature: -55℃~110℃
Initial shrinkage temperature: 80℃
Minimum complete shrinkage temperature: 120℃
Property
Test method
Typical data
Tensile strength
ASTM D 2671
≥14MPa
Tensile strength after aging
(150℃,168hrs)
≥12MPa
Longitudinal shrinkage
0~-10%
Elongation at break
≥400%
Elongation after aging (150℃,168hrs)
≥300%
Breakdown strength
IEC 243
≥20KV/mm
Density
ASTM D 792
1.05g/cm3
Volume resistivity
IEC 93
≥1014Ω•cm
Copper stability
Pass
Adhesive performance
Water absorption
ISO 62
≤0.2%
Softening Point
ASTM E 28
85℃
Peel strength (PE)
4N/cm
Antibacterial
ISO 846
+86 18024295191
Message
damon@zsyilian.com
顶部